Forming Questions and Answers - Principle of Rol Pass: Advertisement
Forming Questions and Answers - Principle of Rol Pass: Advertisement
Forming Questions and Answers - Principle of Rol Pass: Advertisement
Pass
This set of Forming online test focuses on “Principle Of Roll Pass”.
View Answer
Answer: b
Explanation: When the material to be squeezed is rolled at high temperatures, the strength of the
material is found to decrease.
advertisement
2. When the material is entering the roller, what is the tension at the entry zone called?
a) Front tension
b) Above tension
c) Back tension
d) Beneath tension
View Answer
Answer: c
Explanation: When the material is entering the roller, the tension experienced at the entering zone is
called as back tension.
3. When the material is exiting the roller, what is the tension at the exit zone called?
a) Front tension
b) Above tension
c) Back tension
d) Beneath tension
View Answer
Answer: a
Explanation: None.
View Answer
Answer: a
Explanation: Among front tension, above tension, back tension and beneath tension, front tension is
found to increase when the take up wheel rotates at a high speed.
View Answer
Answer: d
Explanation: Among the following, a quick return motion machine is not any type of thread rolling
machine, while the remaining are thread rolling machines.
advertisement
6. Which of the following is not a type of a pass?
a) Roll down pass
b) Starter pass
c) Leader pass
d) Finishing pass
View Answer
Answer: b
Explanation: Among the following types of passes, starter pass is not any type of pass, while the
remaining three are different types of passes.
View Answer
Answer: b
Explanation: Thread rolling has it as one of its advantages, that there is no chip formation taking
place, avoiding a lot of materials to be wasted.
View Answer
Answer: a
Explanation: In a reciprocating flat die machine, there are only two dies which are used, one of them
is stationery, while the other is reciprocating.
View Answer
Answer: c
Explanation: In a reciprocating flat die machine, the reciprocating die stroke depends upon the
thread diameter, and there are 2 dies used in this apparatus, out of which, one is stationery.
advertisement
View Answer
Answer: b
Explanation: Thread rolling is considered to be one of the fastest methods of manufacturing threads
The rate of production is as high as 2000 pieces per minute.