Ironsave-S

Safety Data Sheet

SECTION 1: Identification of the substance/mixture and of the company/undertaking

1.1. Product identifier
Product form : Mixture
Product name : Ironsave-S
1.2. Relevant identified uses of the substance or mixture and uses advised against
Use of the substance/mixture : Corrosion inhibitor for use in hydrochloric acid pickling solutions.
1.3. Details of the supplier of the safety data sheet
SOPRIN S.r.l.
Via dell’Industria 106
31052 Maserada Sul Piave (TV), - Italy
T (+39) 0422 521025 - F (+39) 0422 521060
soprin@soprin.it (Alessandro Padovan)
1.4. Emergency telephone number
Emergency number : (+39) 0422 521025

SECTION 2: Hazards identification

2.1. Classification of the substance or mixture
GHS-US classification
Flam. Liq. 4 H227

2.2. Label elements

GHS-US labelling
Signal word (GHS-US) : Warning
Hazard statements (GHS-US) : H227 - Combustible liquid
Precautionary statements (GHS-US) : P210 - Keep away from heat/sparks/open flames/hot surfaces. - No smoking
P280 - Wear protective gloves/protective clothing/eye protection/face protection
P370+P378 - In case of fire: Use ... for extinction
P403+P235 - Store in a well-ventilated place. Keep cool
P501 - Dispose of contents/container to ...

2.3. Other hazards

No additional information available
2.4. Unknown acute toxicity (GHS-US)
No data available

SECTION 3: Composition/information on ingredients

3.1. Substances
Not applicable
Full text of H-phrases: see section 16
3.2. Mixture
Name Product identifier % GHS-US classification
2,4-Pentanediol, 2-methyl- (CAS No) 107-41-5 1.5 - 2 Skin Irrit. 2, H315
Eye Irrit. 2A, H319

SECTION 4: First aid measures

4.1. Description of first aid measures
First-aid measures after inhalation : Remove to open air. If breathing is irregular, seek medical advice.
First-aid measures after skin contact : Wash immediately with plenty of water. Remove all contaminated clothing. If irritation persists,
seek medical attention. Wash contaminated clothing before using them again.
First-aid measures after eye contact : Irrigate copiously with clean, fresh water for at least 15 minutes. Seek medical advice.
First-aid measures after ingestion : Obtain immediate medical attention. Induce vomiting only if indicated by the doctor. Never give
anything by mouth to an unconscious person.

01/05/2014 EN (English) Page 1

Ironsave-S
Safety Data Sheet

4.2. Most important symptoms and effects, both acute and delayed
Symptoms/injuries after inhalation : None anticipated under normal product handling conditions.
Symptoms/injuries after skin contact : None anticipated under normal product handling conditions.
Symptoms/injuries after eye contact : None anticipated under normal product handling conditions.
Symptoms/injuries after ingestion : None anticipated under normal product handling conditions.
4.3. Indication of any immediate medical attention and special treatment needed
No additional information available

SECTION 5: Firefighting measures

5.1. Extinguishing media
Suitable extinguishing media : Carbon dioxide, foam, powder and water spray.
Unsuitable extinguishing media : None.
5.2. Special hazards arising from the substance or mixture
Fire hazard : Combustible liquid.
Explosion hazard : None known.
5.3. Advice for firefighters
Firefighting instructions : Use jets of water to cool the containers to prevent product decomposition and the development
of substances potentially hazardous for health. Always wear full fire prevention gear. Collect
extinguishing water to prevent it from draining into the sewer system. Dispose of contaminated
water used for extinction and the remains of the fire according to applicable regulations.
Protection during firefighting : Firefighters should wear full protective gear.

SECTION 6: Accidental release measures

6.1. Personal precautions, protective equipment and emergency procedures
6.1.1. For non-emergency personnel
Eliminate all sources of ignition (cigarettes, flames, sparks, etc.) from the leakage site. If there are no contraindications, spray solid products with water
to prevent the formation of dust. Use breathing equipment if fumes or powders are released into the air. Block the leakage if there is no hazard. Do not
handle damaged containers or the leaked product before donning appropriate protective gear.
6.1.2. For emergency responders
No additional information available
6.2. Environmental precautions
Avoid release to the environment.
6.3. Methods and material for containment and cleaning up
For containment : Stop the flow of material, if this is without risk.
Methods for cleaning up : Use inert absorbent material (sand, vermiculite, diatomeous earth, Kieselguhr, etc.) to soak up
leaked product. Collect the majority of the remaining material and deposit it in containers for
disposal. If there are no contraindications, use jets of water to eliminate product residues. Make
sure the leakage site is well aired.
6.4. Reference to other sections
No additional information available

SECTION 7: Handling and storage

7.1. Precautions for safe handling
Precautions for safe handling : Do not smoke while handling.
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions : Store in a well ventilated place, keep far away from sources of heat, bright flames and sparks
and other sources of ignition.
7.3. Specific end use(s)
Corrosion inhibitor for use in hydrochloric acid pickling solutions.

SECTION 8: Exposure controls/personal protection

8.1. Control parameters

2,4-Pentanediol, 2-methyl- (107-41-5)

USA ACGIH ACGIH Ceiling (ppm) 25 ppm

01/05/2014 EN (English) 2/5

Ironsave-S
Safety Data Sheet

8.2. Exposure controls

Appropriate engineering controls : Local exhaust and general ventilation must be adequate to meet exposure standards.
Hand protection : Use impervious gloves such as neoprene, nitrile, or rubber for hand protection.
Eye protection : Wear protective airtight goggles.
Skin and body protection : Wear suitable working clothes.
Respiratory protection : If airborne concentrations are above the applicable exposure limits, use NIOSH approved
respiratory protection.

SECTION 9: Physical and chemical properties

9.1. Information on basic physical and chemical properties
Physical state : Liquid
Colour : Colourless.
Odour : Slightly pungent
Odour threshold : No data available
pH : 5.5
Relative evaporation rate (butylacetate=1) : No data available
Melting point : No data available
Freezing point : < 0 °C
Boiling point : No data available
Flash point : > 70 °C
Self ignition temperature : No data available
Decomposition temperature : No data available
Flammability (solid, gas) : No data available
Vapour pressure : No data available
Relative vapour density at 20 °C : No data available
Relative density : No data available
Specific gravity : 1000 kg/m³
Solubility : No data available
Log Pow : No data available
Log Kow : No data available
Viscosity, kinematic : No data available
Viscosity, dynamic : No data available
Explosive properties : No data available
Oxidising properties : No data available
Explosive limits : No data available

9.2. Other information

No additional information available

SECTION 10: Stability and reactivity

10.1. Reactivity
No additional information available
10.2. Chemical stability
The product is stable at normal handling and storage conditions.
10.3. Possibility of hazardous reactions
Will not occur.
10.4. Conditions to avoid
None.
10.5. Incompatible materials
Strong acids and oxidizers
10.6. Hazardous decomposition products
In the event of thermal decomposition or fire, vapours potentially dangerous to health may be released.

01/05/2014 EN (English) 3/5

Ironsave-S
Safety Data Sheet

SECTION 11: Toxicological information

11.1. Information on toxicological effects

Acute toxicity : Not classified

2,4-Pentanediol, 2-methyl- (107-41-5)

LD50 oral rat 3692 mg/kg
LC50 inhalation rat (mg/l) > 310 mg/m³ (Exposure time: 1 h)
Skin corrosion/irritation : Not classified
pH: 5.5
Serious eye damage/irritation : Not classified
pH: 5.5
Respiratory or skin sensitisation : Not classified
Germ cell mutagenicity : Not classified
Carcinogenicity : Not classified
Reproductive toxicity : Not classified
Specific target organ toxicity (single exposure) : Not classified

Specific target organ toxicity (repeated : Not classified

exposure)
Aspiration hazard : Not classified

SECTION 12: Ecological information

12.1. Toxicity

2,4-Pentanediol, 2-methyl- (107-41-5)

LC50 fishes 1 10500 - 11000 mg/l (Exposure time: 96 h - Species: Pimephales promelas [flow-through])
EC50 Daphnia 1 2700 - 3700 mg/l (Exposure time: 48 h - Species: Daphnia magna)
LC50 fish 2 10000 mg/l (Exposure time: 96 h - Species: Lepomis macrochirus [static])

12.2. Persistence and degradability

No additional information available

12.3. Bioaccumulative potential

2,4-Pentanediol, 2-methyl- (107-41-5)

Log Pow < 0.14

12.4. Mobility in soil

No additional information available

12.5. Other adverse effects

No additional information available

SECTION 13: Disposal considerations

13.1. Waste treatment methods
Waste disposal recommendations : Dispose of contents/container in accordance with local/regional/national/international regulations.

SECTION 14: Transport information

In accordance with DOT
Not a dangerous good in sense of transport regulations

SECTION 15: Regulatory information

15.1. US Federal regulations

2,4-Pentanediol, 2-methyl- (107-41-5)

Listed on the United States TSCA (Toxic Substances Control Act) inventory

01/05/2014 EN (English) 4/5

Ironsave-S
Safety Data Sheet

15.2. US State regulations

2,4-Pentanediol, 2-methyl- (107-41-5)

U.S. - Massachusetts - Right To Know List
U.S. - Minnesota - Hazardous Substance List
U.S. - New Jersey - Right to Know Hazardous Substance List
U.S. - Pennsylvania - RTK (Right to Know) List

SECTION 16: Other information

Full text of H-phrases:

------ Eye Irrit. 2A Serious eye damage/eye irritation, Category 2A
------ Flam. Liq. 4 Flammable liquids, Category 4
------ Skin Irrit. 2 Skin corrosion/irritation, Category 2
------ H227 Combustible liquid
------ H315 Causes skin irritation
------ H319 Causes serious eye irritation

This information is based on our current knowledge and is intended to describe the product for the purposes of health, safety and environmental requirements only. It should not therefore be construed as
guaranteeing any specific property of the product

01/05/2014 EN (English) 5/5