EDI FlexAir TSeries Spec Sheet
EDI FlexAir TSeries Spec Sheet
EDI FlexAir TSeries Spec Sheet
• Precision die cut openings for high • ABS and PVC construction for maximum
oxygen transfer, uniform air release, and chemical, temperature, and UV resistance
low operating pressure • Rugged, heavy duty construction with 3/4
• High capacity membrane options available inch stainless steel NPT (male) inlet plus
for maximum airflow and low operating special thru-tube inlets also available
pressure • Non-buoyant design for reduced uplift and
• Ideal for coarse bubble diffuser upgrades stress on mounting connection
• Advanced technology premium quality • Mounts on any pipe material (PVC, ABS,
membrane materials available in EPDM, CPVC, SS, etc.) or size
urethane, and special polymer blends • Standard 304 or 316 stainless steel and
• Available in 62 mm and 91 mm diameter non-metallic membrane retainer clamps are
up to 1000 mm long tubes available
• Triple check valve design prevents entry • Standard sizes IN STOCK for immediate
of liquid/solids into piping. Ideal for on / shipment
off applications
• Resistant to fouling and plugging for low
maintenance
• Economical capital 4 3
cost and ease of
installation
2
5
1 6
7
Diffuser Length
Membrane
Retainer Clamp
Diffuser Inlet Adapter
Diffuser
Diameter
Model Diffuser Type Design Airflow Overall Length Active Surface Area Dry Weight Net Operating Buoyancy
(membrane) (membrane) (membrane) (diffuser) (diffuser)
• Optimum oxygen transfer efficiency is achieved when operating in the middle to low end of the airflow range.
The approximate operating pressure of the diffuser at the mid-range is 18-25 inches H2O (4.5-6.2 kPa).
• Operating the unit at the high end of the range will result in reduced performance and increased operating pressure.
Use the maximum airflow value for short term operations such as peak loads or system maintenance.