Protective Lubricant For Air Compressor System MSDS PDF

Material Safety Data Sheet – Protective Lubricant for Air Compressor System
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Product name: Protective Lubricant for Air Compressor System

Other/generic names: Synthetic hydrocarbon and ester blend
Product use: Lubricant for air compressors
Manufacturer: IMT
In case of emergency: 800-424-9300
2. HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW: A straw colored liquid with a mild petroleum odor. Repeated or
prolonged contact may irritate skin and eyes. Mists can irritate respiratory tract. Can be
ignited at elevated temperatures but is not considered “flammable”. Discharge can be toxic
to aquatic species. Keep out of sewers and waterways.
Potential Health Hazards

Considered hazardous under the OSHA Hazard Communication Standard.
Skin: May cause irritation, especially with prolonged or repeated contact.
Eyes: Can irritate the eyes.
Inhalation: Can cause respiratory irritation.
Ingestion: May irritate digestive tract and cause nausea and discomfort. Of low oral toxicity.
Delayed effects: None anticipated
Ingredients found on one of the OSHA designated carcinogen lists are listed below.
Ingredient Name NTP Status IARC Status OSHA List
No ingredients listed in this section. = =
3. COMPOSITION/INFORMATION ON INGREDIENTS
Ingredient Name CAS Number Weight %

Synthetic Hydrocarbon oils and esters Trade secret 100
Trace impurities and additional material names not listed above may also appear in Section 15 toward the end of the
MSDS. These materials may be listed for local "Right-To-Know" compliance and for other reasons.
4. FIRST AID MEASURES
Skin: Wash with soap and water. Remove contaminated clothing and launder before reuse. If irritation
develops, seek medical advice.
Eyes: Rinse in running water for up to 15 minutes. Get medical assistance for persisting irritation.
Inhalation: Remove to fresh air. Get medical assistance if irritation persists or for any other symptom.
Ingestion: Do not induce vomiting. Get medical assistance for discomfort or any other symptom.
Advice to physician: Treat symptomatically.
MSDS: Protective Lubricant for Air Compressor System Page 1 of 5

5. FIRE FIGHTING MEASURES
Flammable Properties
Flash Point & Method 518ºF ( 270ºC) Cleveland Open Cup
Autoignition Temperature: Not established
Lower/Upper Flame Limits Not established
Flame Propagation Rate (solids): Not applicable
OSHA Flammability Class: IIIB
Extinguishing Media: Use foam, carbon dioxide, dry chemical or water spray. Solid water
streams may spread burning liquid.
Unusual Fire And Explosion Hazards: Burning liquid produces toxic and irritating fumes. Burning liquid may
also float on water.
Special Fire Fighting Wear self contained breathing apparatus. Avoid prolonged contact
Precautions/Instructions: with liquid.
6. ACCIDENTAL RELEASE MEASURES
IN CASE OF SPILL OR OTHER RELEASE: Wear proper protective clothing. Pick up spilled articles and place into
container. Small spills: Absorb spilled material with clay or other inert absorbent. Place into drums for disposal. (See
section 13). Large spills: Dike spilled material with clay or soil. Pump into containers for disposal. Do not allow liquid
to enter sewers or waterways.
7. HANDLING AND STORAGE
Normal Handling: Avoid contact with skin and eyes. Do not breathe product mists.
Storage Recommendations: Store in a clean, dry area and keep containers closed. Do not store with
oxidizing agents.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Engineering Controls: General mechanical ventilation is sufficient for most circumstances. Local exhaust may be
required if product mists are formed.
Personal Protective Equipment

Skin Protection: Wear neoprene or other oil resistant impervious gloves.
Eye Protection: Wear safety glasses with eye shield while handling product.
Respiratory Protection: Not normally required for properly ventilated areas
Additional Recommendations: A source of running water. May include safety shower or eyewash.
Exposure Guidelines
Ingredient Name ACGIH TLV OSHA PEL NIOSH IDLH

3
Aniline TWA: 2 ppm TWA: 19 mg/m 100 ppm
3 3 3
Phenothiazine TWA: 5 mg/m Skin: TWA 5 mg/m TWA 5 mg/m
* = NIOSH REL
** = Workplace Environmental Exposure Level (AIHA).
*** = Biological Exposure Index (ACGIH).

Other Exposure Limits For Potential Decomposition Products: None
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: Clear and Bright

Physical State: Liquid
Molecular Weight: Mixture
Chemical Formula: Mixture
Odor: Mild petroleum odor
Specific Gravity (water = 1.0): 0.86
Solubility In Water (wt. %): Negligible
Boiling Point: Not determined
Viscosity 68 cSt @ 104 ºF (40 ºC)
Flash Point 518ºF (270ºC)
Autoignition Temperature Not established
Lower/Upper Flame Limits Not established
10. STABILITY AND REACTIVITY
Normally Stable? Normally stable.

(Conditions To Avoid):
Incompatibilities: Avoid contact with oxidizers or acids. Oxidizers may cause ignition.
Acids may react with product.
Hazardous Decomposition Products: Carbon dioxide, carbon monoxide, hydrocarbons.
Hazardous Polymerization: Will not occur.
11. TOXICOLOGICAL INFORMATION
Immediate (acute) effects:

Product has not been tested as a mixture but most components are of low oral toxicity. Major components are mildly
irritating but can cause irritation with repeated or prolonged exposure.
Delayed (subchronic and chronic) effects:

Based upon ingredients, no effects anticipated.
Other Data:
Carcinogenicity ACGIH – A3 - Aniline
Endocrine Disruptor Not available
Chemical Name LD50 Oral LD50 Dermal LC50 Inhalation
N-Phenyl-beta-naphthylamine 8730 mg/kg (Rat)
Aniline 250 mg/kg (Rat) 1400 mg/kg (Rat)
Phenothiazine 1330 mg/kg (Rat) 9400 mg/kg (Rabbit) 200 mg/L (Rat) 1 h

12. ECOLOGICAL INFORMATION
Toxicity to
Chemical Name
Data Sheet –Toxicity
Material SafetyAlgae to Fish
Protective Microtox
Lubricant Water Flea
for Air Compressor System
Aniline LC50 = 75.5 mg/L 96 h EC50 = 425 mg/L 5 min
13. DISPOSAL CONSIDERATIONS
RCRA
Is the unused product a RCRA No
hazardous waste if discarded?
If yes, the RCRA ID number is:
Other Disposal Considerations: Observe all Federal, State, and Local Environmental regulations.
Do not send this product to a landfill. It is recommended that this product be incinerated in a licensed facility.
The information offered here is for the product as shipped. Use and/or alterations to the product such as mixing with
other materials may significantly change the characteristics of the material and alter the RCRA classification and the
proper disposal method.
This product contains one or more substances that are listed with the State of California as a hazardous waste – Aniline
14. TRANSPORT INFORMATION
US DOT Proper Shipping Name: Not regulated

US DOT Hazard Class & Packing Group: Not regulated
US DOT ID Number: Not regulated
For additional information on shipping regulations affecting this material, contact the information number found in
Section 1.
15. REGULATORY INFORMATION
Toxic Substances Control Act (TSCA)

TSCA Inventory Status: All ingredients are listed on the TSCA chemical inventory.
Other TSCA Issues: None
SARA Title III/CERCLA
Reportable Quantities (RQs) and/or Threshold Planning Quantities (TPQs) exist for the following ingredients.
Ingredient Name SARA/CERCLA RQ (lb) SARA EHS TPQ (lb)
No ingredients listed in this section. ----- -----
Spills or releases resulting in the loss of any ingredient at or above its RQ requires immediate notification to
the National Response Center [(800) 424-8802] and to your Local Emergency Planning Committee.
Section 311 Hazard Class: Immediate
SARA 313 Toxic Chemicals:

The following metallic components are listed as SARA 313 "Toxic Chemicals" and potential subject to annual
SARA 313 reporting. Weight percents are found in Section 3.
Ingredient Name Comment
No ingredients listed in this section.

Material Safety Data Sheet – IMT Reciprocating Compressor Oil
State Right-To-Know
In addition to the ingredients found in Section 2, the following are listed for state right-to-know purposes.
Chemical
Massachusetts New Jersey Pennsylvania Illinois Rhode Island
Name
Phenothiazine X X X X
Other Regulatory Information:
WHMIS Classification D2B This product has been classified in accordance with hazard criteria of the
(Canada): Controlled Products Regulations and the MSDS contains all the information required
by the Controlled Products Regulations.
Foreign Inventory Status: Some ingredients are not listed on the Canadian DSL.
California Proposition 65: This product contains a substance on the list of Proposition 65 chemicals.
16. OTHER INFORMATION
HMIS Ratings Health 1, Fire 1, Reactivity 0

Current Issue Date: March 20, 2012
Previous Issue Date:
Changes To MSDS From Previous
Issue Date Are Due To The Following:
PPE
NFPA HMIS
Transport Symbol
Not Regulated

Protective Lubricant For Air Compressor System MSDS PDF

Uploaded by

Copyright:

Available Formats

Protective Lubricant For Air Compressor System MSDS PDF

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Protective Lubricant For Air Compressor System MSDS PDF

Uploaded by

Copyright:

Available Formats

Material Safety Data Sheet – Protective Lubricant for Air Compressor System

1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION

Product name: Protective Lubricant for Air Compressor System

Potential Health Hazards

Ingredient Name CAS Number Weight %

4. FIRST AID MEASURES

MSDS: Protective Lubricant for Air Compressor System Page 1 of 5

5. FIRE FIGHTING MEASURES

6. ACCIDENTAL RELEASE MEASURES

7. HANDLING AND STORAGE

8. EXPOSURE CONTROLS/PERSONAL PROTECTION

Personal Protective Equipment

Ingredient Name ACGIH TLV OSHA PEL NIOSH IDLH

MSDS: Protective Lubricant for Air Compressor System Page 2 of 5

Other Exposure Limits For Potential Decomposition Products: None

9. PHYSICAL AND CHEMICAL PROPERTIES

Appearance: Clear and Bright

10. STABILITY AND REACTIVITY

Normally Stable? Normally stable.

11. TOXICOLOGICAL INFORMATION

Immediate (acute) effects:

Delayed (subchronic and chronic) effects:

Carcinogenicity ACGIH – A3 - Aniline

Endocrine Disruptor Not available

Chemical Name LD50 Oral LD50 Dermal LC50 Inhalation

N-Phenyl-beta-naphthylamine 8730 mg/kg (Rat)

Aniline 250 mg/kg (Rat) 1400 mg/kg (Rat)

MSDS: Protective Lubricant for Air Compressor System Page 3 of 5

12. ECOLOGICAL INFORMATION

13. DISPOSAL CONSIDERATIONS

14. TRANSPORT INFORMATION

US DOT Proper Shipping Name: Not regulated

15. REGULATORY INFORMATION

Toxic Substances Control Act (TSCA)

SARA Title III/CERCLA

Section 311 Hazard Class: Immediate

SARA 313 Toxic Chemicals:

MSDS: Protective Lubricant for Air Compressor System Page 4 of 5

Other Regulatory Information:

16. OTHER INFORMATION

HMIS Ratings Health 1, Fire 1, Reactivity 0

MSDS: Protective Lubricant for Air Compressor System Page 5 of 5

You might also like