Nothing Special   »   [go: up one dir, main page]

Launching of Liferaft: HRU Activates Auto

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 1

Page 1 of 1

Launching of Liferaft
Launching of life raft when the ship sinks and HRU activates (Auto)
 When the ship sinks up to 4 metres, the water pressure will activate a sharp knife
in the HRU
 It will cut the securing rope around the container/canister of the raft and the raft
will float free
 As the ship sinks further, the painter line will stretch and it will inflate the life raft
 Due to the increase in buoyant pressure, the weak link will break at around 2.2 kN
+/- 0.4 and the raft will be on the surface

Launching the life raft MANUALLY


 Take out the painter of the raft
 Fasten it to the ship side at a strong point
 Remove the railing and check overboard for any obstructions
 Unfasten the hook from the cradle
 Two people can lift the life raft and throw it overboard
 After its thrown, pull the painter sharp until the life raft inflates
 With the painter, pull it towards the ship side
 Lower the embarkation ladder or jump directly onto the life raft depending on the
situation and the time at hand
 Sit order wide face to face to prevent any imbalance
 Ensure SART and EPIRB have been carried
 Take a head count
 Cut the painter using the knife given and using the paddle or the anchor, clear away
from the ship

If the life raft inflates and it is upside down, the raft has a righting strap which is capable
of stabilize it. Climb onto the CO2 cylinder and pull it in the same direction as the wind
to do so.

Launching the life raft by the DAVIT


 Remove ship’s hand rail
 Remove lashings from the container
 Lower the davit and lock it with the lifting shackle
 Secure canister lines outboard
 Secure bowsing line
 Pull the painter out approximately 5-6 metres
 Secure the painter line
 Pull the full length of the painter
 Now lift the life raft canister up to some height
 Pull the painter sharply and let it inflate
 After it inflates, secure the liferaft
 One person should go in and make some checks
 Collect the SART and EPIRB
 Go inside and sit evenly
 Release the bowsing line and pass to the raft
 Check if the launching area is clear
 Lower the raft using the brake release
 Operate hook release 1m above the water or allow the raft to ride a crest of the wave
to put the load on the water and it will automatically release
 Cut the painter and clear away

You might also like