Model Question Paper Four Year B.Tech Degree End Examination Third Semester Examination Mechanical Engineering Machine Drawing (MD)
Model Question Paper Four Year B.Tech Degree End Examination Third Semester Examination Mechanical Engineering Machine Drawing (MD)
Model Question Paper Four Year B.Tech Degree End Examination Third Semester Examination Mechanical Engineering Machine Drawing (MD)
Max.Marks:70
Note: 1.Answer ONE QUESTION from UNIT-I & UNIT-II
2. UNIT-III is compulsory
3. Assume any missing data
UNIT-I
1. Draw the sectional view from the front and, view from the side of a cotter joint with
sleeve used to connect two rods of 50mm diameter each.
(15)
2. Draw half sectional view from the front, with left half in section and view from above
of a bushed journal bearing, suitable for supporting a shaft of diameter 25mm. (15)
UNIT-II
3. Draw (a) sectional view from the front and (b) view from the above of a single
riveted, double strap butt joint to join plates of thickness 10 mm.
(15)
4. Sketch the required views, indicating proportions of compression coupling to
connect two shafts, each of diameter 30 mm.
(15)
UNIT-III
5. Assemble all parts of the stuffing box for a vertical steam engine, shown in Fig (1) and
draw half sectional view from the front, with left half in section and view from above
(40)
Fig(1)