Roof section

Truss Roof Section Drawing DWG File; download free DWG file wooden truss roof section drawing with dimension and description details.

I have a (very sligthly sloped) flat roof deck held up by 2x8's to which the ceiling for the upstairs room is attached. Therefore, the space between the ceiling and the roof deck is about 7 inches - much like a cathedral ceiling, except that it's basically flat. In each 16" wide channel there is a pitiful layer of R13 fiberglass batt attached to vapor barrier paper laid against the ceiling, with cold air blowing continuously over and arround it from openings at either end ("vents").

Figured I should post up the final plans here too. Shifted them around slightly, mainly due to the front stairs. Thought we liked an open stair case and the large window heading down, but after much thought we decided the amount of noise transferred from the basement will most likely be overly...annoying. However on the flip side, by reducing the glass in that window, it dropped my solar glass to floor ratio from a high 13% down to a better 9% since there is low thermal mass on the interior…

Image 17 of 20 from gallery of House PRO.CRE.AR 01 / FRAM arquitectos. Section BB

Roof section plan layout file, dimension detail, naming detail, reinforcement detail, bolt nut detail, brick wall detail, hatching detail, etc.

Image from THE RED ROOF by TAA DESIGN in Vietnam

10 posts published by Beacon Design Team during February 2011

Section diagrams of a wood house with a curvy roof.

A band of glazing inserted beneath the jagged roofline of this house near Mount Fuji is illuminated after dark, highlighting its snow-shedding shape