Nothing Special   »   [go: up one dir, main page]

CERN Accelerating science

CERN Document Server 2,028 registres trobats  1 - 10següentfinal  anar al registre: La cerca s'ha fet en 1.07 segons. 
1.
Hardware Limitations at Injection / Vlachodimitropoulos, V (CERN) ; Barnes, M J (CERN) ; Bartosik, H (CERN) ; Bracco, C (CERN) ; Chmielinska, A (CERN) ; Ducimetière, L (CERN) ; Fraser, M (CERN) ; Cid, L Vega (CERN) ; Velotti, F M (CERN) ; Weterings, W (CERN)
Hardware limitations due to the intercepting devices in the SPS, the SPS-to-LHC transfer lines and the LHC will be briefly reviewed with potential operation beam in mind for 2018. Heating issues in the LHC injection kicker magnet (MKI) are also a possible future limiting factor for LHC's availability [...]
2019 - 4 p. - Published in : (2019) , pp. 133-136 Fulltext: PDF;
In : 8th Evian Workshop on LHC beam operation, Evian Les Bains, France, 12 - 14 Dec 2017, pp.133-136
2.
Preliminary Results from Validation Measurements of the Longitudinal Power Deposition Model for the LHC Injection Kicker Magnet / Vlachodimitropoulos, Vasileios (CERN) ; Barnes, Michael (CERN) ; Chmielinska, Agnieszka (CERN)
During Run 1 of the LHC, one of the injection kicker magnets (MKIs) exhibited an excessively high ferrite temperature, caused by coupling of the high intensity beam to the real impedance of the magnet. Beam-screen upgrades, implemented during Long Shutdown 1 (LS1), have been very effective in reducing beam coupling impedance and since then the MKIs have not limited LHC's availability. [...]
2018 - 4 p. - Published in : 10.18429/JACoW-IPAC2018-WEPMK005 Fulltext: PDF;
In : 9th International Particle Accelerator Conference, Vancouver, Canada, 29 Apr - 4 May 2018, pp.WEPMK005
3.
Longitudinal Impedance Analysis of an Upgraded LHC Injection Kicker Magnet / Vlachodimitropoulos, Vasileios (CERN) ; Barnes, Michael (CERN) ; Vega Cid, Lorena (CERN) ; Weterings, Wim (CERN) ; Ducimetière, L. (CERN)
Prior to Long Shutdown 1 (LS1) one of the LHC injection kickers (MKIs) occasionally exhibited high temperatures leading to significant turnaround times. After a successful impedance mitigation campaign during LS1, the MKI ferrite yokes have remained below their Curie point and have not limited LHC's availability. [...]
2018 - 4 p. - Published in : 10.18429/JACoW-IPAC2018-WEPMK002 Fulltext: PDF;
In : 9th International Particle Accelerator Conference, Vancouver, Canada, 29 Apr - 4 May 2018, pp.WEPMK002
4.
Operational experience of a prototype LHC injection kicker magnet with a low SEY coating and redistributed power deposition / Barnes, Michael (CERN) ; Bracco, Chiara (CERN) ; Bregliozzi, Giuseppe (CERN) ; Chmielinska, Agnieszka (Ecole Polytechnique, Lausanne ; CERN) ; Ducimetière, Laurent (CERN) ; Goddard, Brennan (CERN) ; Iadarola, Giovanni (CERN) ; Kramer, Thomas (CERN) ; Vega Cid, Lorena (Madrid, Polytechnic U. ; CERN) ; Vlachodimitropoulos, Vasileios (CERN) et al.
In the event that it is necessary to exchange an LHC injection kicker magnet (MKI), the newly installed kicker magnet would limit operation for a few hundred hours due to dynamic vacuum. A surface coating with a low secondary electron yield, applied to the inner surface of an alumina tube to reduce dynamic vacuum activity without increasing the probability of Unidentified Falling Objects, and which is compatible with the high voltage environment, was included in an upgraded MKI installed in the LHC during the 2017-18 Year End Technical Stop. [...]
CERN-ACC-2019-249.- 2019 - 7 p. - Published in : (2019) , pp. THPRB072
- Published in : J. Phys.: Conf. Ser. 1350 (2019) 012145 Preprint: PDF;
In : 10th International Particle Accelerator Conference, Melbourne, Australia, 19 - 24 May 2019, pp.THPRB072
5.
Studies towards the new beam screen system of the LHC injection kicker magnet for HL-LHC operation / Vlachodimitropoulos, Vasileios (CERN) ; Barnes, Michael (CERN) ; Chmielinska, Agnieszka (Ecole Polytechnique, Lausanne ; CERN) ; Ducimetière, Laurent (CERN) ; Vega Cid, Lorena (CERN ; Madrid, Polytechnic U.) ; Weterings, Wim (CERN)
Although no heating issues were observed in the Large Hadron Collider’s (LHC) injection kicker magnets (MKIs) during Run 2, simulations suggest that for operation with the high intensity beams of the High Luminosity LHC (HL-LHC) project, the magnet’s ferrite yokes will reach their Curie temperature, thus leading to long turnaround times before a new beam can be safely injected into the machine. To safely enter the HL-LHC era, a campaign to redesign the kicker’s beam screen was launched. [...]
CERN-ACC-2019-247.- 2019 - 4 p. - Published in : 10.18429/JACoW-IPAC2019-THPRB074 Fulltext from publisher: PDF;
In : 10th International Particle Accelerator Conference, Melbourne, Australia, 19 - 24 May 2019, pp.THPRB074
6.
Transverse impedance measurements and simulations of the LHC injection kicker magnet / Vlachodimitropoulos, Vasileios (CERN) ; Barnes, Michael (CERN) ; Chmielinska, Agnieszka (Ecole Polytechnique, Lausanne ; CERN) ; Ducimetière, Laurent (CERN)
Kicker magnets contribute significantly to the total impedance budget of many accelerators. Of particular interest, from a beam stability point of view, is the transverse beam coupling impedance (TBCI) that is used to determine intensity limitations of a machine. [...]
CERN-ACC-2019-246.- 2019 - 4 p. - Published in : 10.18429/JACoW-IPAC2019-THPRB075 Fulltext from publisher: PDF;
In : 10th International Particle Accelerator Conference, Melbourne, Australia, 19 - 24 May 2019, pp.THPRB075
7.
An Upgraded LHC Injection Kicker Magnet / Barnes, Michael (CERN) ; Bracco, Chiara (CERN) ; Bregliozzi, Giuseppe (CERN) ; Chmielinska, Agnieszka (CERN) ; Ducimetière, Laurent (CERN) ; Goddard, Brennan (CERN) ; Kramer, Thomas (CERN) ; Neupert, Holger (CERN) ; Vega Cid, Lorena (CERN) ; Vlachodimitropoulos, Vasileios (CERN) et al.
An upgrade of the LHC injection kickers is necessary for HL-LHC to avoid excessive beam induced heating of these magnets: the intensity of the HL-LHC beam will be twice that of LHC. In addition, in the event that it is necessary to exchange an injection kicker magnet, the newly installed kicker magnet would limit HL-LHC operation for a few hundred hours due to dynamic vacuum activity. [...]
2018 - 4 p. - Published in : 10.18429/JACoW-IPAC2018-WEPMK003 Fulltext: PDF;
In : 9th International Particle Accelerator Conference, Vancouver, Canada, 29 Apr - 4 May 2018, pp.WEPMK003
8.
Impact of LHC and SPS Injection Kicker Rise Times on Lhc Filling Schemes and Luminosity Reach / Bartmann, Wolfgang (CERN) ; Barnes, Michael (CERN) ; Boyd, Jamie (CERN) ; Carlier, Etienne (CERN) ; Chmielinska, Agnieszka (CERN) ; Goddard, Brennan (CERN) ; Kotzian, Gerd (CERN) ; Schwick, Christoph (CERN) ; Stoel, Linda (CERN) ; Valuch, Daniel (CERN) et al.
The 2016 LHC proton filling schemes generally used a spacing between injections of batches of bunches into SPS and LHC corresponding to the design report specification for the SPS and LHC injection kicker rise times, respectively. A reduction of the batch spacing can be directly used to increase luminosity without detrimental effects on beam stability, and with no increase in the number of events per crossing seen by the experiments. [...]
CERN-ACC-2017-196.- 2017 - 4 p. - Published in : 10.18429/JACoW-IPAC2017-TUPVA007 Fulltext: PDF;
In : 8th International Particle Accelerator Conference, Copenhagen, Denmark, 14 - 19 May 2017, pp.TUPVA007
9.
Study of an Improved Beam Screen Design for the LHC Injection Kicker Magnet for HL-LHC / Vlachodimitropoulos, Vasileios (CERN) ; Barnes, Michael (CERN) ; Ducimetière, Laurent (CERN) ; Vega Cid, Lorena (CERN) ; Weterings, Wim (CERN)
During Run 1 of the LHC, one of the injection kicker magnets (MKIs) occasionally exhibited an excessively high ferrite temperature, caused by coupling of the high intensity beam to the real impedance of the magnet. Beam-screen upgrades have been very effective in reducing beam coupling impedance during Run 2 [...]
CERN-ACC-2017-177.- 2017 - 4 p. - Published in : 10.18429/JACoW-IPAC2017-WEPVA094 Fulltext: PDF;
In : 8th International Particle Accelerator Conference, Copenhagen, Denmark, 14 - 19 May 2017, pp.WEPVA094
10.
Preliminary Design of a Cooling System for the LHC Injection Kicker Magnets / Vega Cid, Lorena (CERN) ; Abánades, Alberto (Madrid, Polytechnic U.) ; Barnes, Michael (CERN) ; Ducimetière, Laurent (CERN) ; Moester, Max (CERN) ; Vlachodimitropoulos, Vasileios (CERN) ; Weterings, Wim (CERN)
The CERN Large Hadron Collider (LHC) is equipped with two fast pulsed magnet systems (MKIs) that inject particle beams from the injector chain. Future operation for High Luminosity LHC (HL-LHC) with high intensity beams will cause heating of the ferrite yokes of the MKIs beyond their Curie temperature, preventing injection until the yokes cool down. [...]
2018 - 4 p. - Published in : 10.18429/JACoW-IPAC2018-WEPMK001 Fulltext: PDF;
In : 9th International Particle Accelerator Conference, Vancouver, Canada, 29 Apr - 4 May 2018, pp.WEPMK001

No heu trobat el que estaveu cercant? Proveu la vostra cerca a:
recid:2813538 dins Amazon
recid:2813538 dins CERN EDMS
recid:2813538 dins CERN Intranet
recid:2813538 dins CiteSeer
recid:2813538 dins Google Books
recid:2813538 dins Google Scholar
recid:2813538 dins Google Web
recid:2813538 dins IEC
recid:2813538 dins IHS
recid:2813538 dins INSPIRE
recid:2813538 dins ISO
recid:2813538 dins KISS Books/Journals
recid:2813538 dins KISS Preprints
recid:2813538 dins NEBIS
recid:2813538 dins SLAC Library Catalog