|
1.
|
|
|
2.
|
Mechanical stress analysis during a quench in CLIQ protected 16 T dipole magnets designed for the future circular collider
/ Zhao, Junjie (Lanzhou U.) ; Prioli, Marco (CERN) ; Stenvall, Antti (Tampere U. of Tech.) ; Salmi, Tiina (Tampere U. of Tech.) ; Gao, Yuanwen (Lanzhou U.) ; Caiffi, Barbara (INFN, Genoa) ; Lorin, Clement (Saclay) ; Marinozzi, Vittorio (Milan Bicocca U. ; INFN, Milan) ; Farinon, Stefania (INFN, Genoa) ; Sorbi, Massimo (Milan Bicocca U. ; INFN, Milan)
Protecting the magnets in case of a quench is a challenge for the 16 T superconducting dipole magnets presently designed for the 100 TeV: Future Circular Collider (FCC). These magnets are driven to the foreseen technological limits in terms of critical current, mechanical strength and quench protection. [...]
2018 - 8 p.
- Published in : Physica C 550 (2018) 27-34
|
|
|
3.
|
Analytical Evaluation of Dipole Performance Limits for a Muon Collider
/ Novelli, Daniel (U. Rome La Sapienza (main) ; INFN, Genoa) ; Bersani, Andrea (INFN, Genoa) ; Bottura, Luca (CERN) ; Caiffi, Barbara (INFN, Genoa) ; Fabbri, Siara (CERN) ; Farinon, Stefania (INFN, Genoa) ; Mariotto, Samuele (INFN, Milan ; Milan U. ; LASA, Segrate) ; Musenich, Riccardo (INFN, Genoa) ; Pampaloni, Alessandra (INFN, Genoa) ; Salmi, Tiina (Tampere U. of Tech.) et al.
Following the recommendation of the Updated European Strategy for Particle Physics, an International Muon Collider Collaboration has been formed and is currently studying the feasibility of a 10 TeV center-of-mass energy muon collider facility. Several technical challenges must be faced, mainly due to the limited muon lifetime at rest, 2.2 µs. [...]
2024 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 34 (2024) 4002405
|
|
|
4.
|
Towards a Muon Collider
/ Accettura, Carlotta (CERN) ; Adams, Dean (Rutherford) ; Agarwal, Rohit (UC, Berkeley (main)) ; Ahdida, Claudia (CERN) ; Aimè, Chiara (Pavia U. ; INFN, Pavia) ; Amapane, Nicola (INFN, Turin ; Turin U.) ; Amorim, David (CERN) ; Andreetto, Paolo (INFN, Padua) ; Anulli, Fabio (INFN, Rome) ; Appleby, Robert (Manchester U.) et al.
A muon collider would enable the big jump ahead in energy reach that is needed for a fruitful exploration of fundamental interactions. The challenges of producing muon collisions at high luminosity and 10 TeV centre of mass energy are being investigated by the recently-formed International Muon Collider Collaboration. [...]
arXiv:2303.08533; FERMILAB-PUB-23-123-AD-PPD-T.-
2023-09-26 - 118 p.
- Published in : Eur. Phys. J. C
- Published in : Eur. Phys. J. C
Fulltext: 2303.08533 - PDF; FERMILAB-PUB-23-123-AD-PPD-T - PDF; Fulltext from Publisher: PDF; External links: JLab Document Server; Fermilab Library Server
|
|
|
5.
|
Optimization of the High Order Correctors for HL-LHC Toward the Series Production
/ Statera, Marco (INFN, Milan) ; Alessandria, Franco (INFN, Milan ; Milan U.) ; Bellomo, Giovanni (INFN, Milan ; Milan U.) ; Broggi, Francesco (INFN, Milan) ; Imeri, Luca (INFN, Milan) ; Leone, Augusto (INFN, Milan) ; Mariotto, Samuele (INFN, Milan ; Milan U.) ; Paccalini, Antonio (INFN, Milan) ; Pasini, Alessandro (INFN, Milan) ; Pedrini, Danilo (INFN, Milan) et al.
INFN is developing at the LASA lab (Milano, Italy) the High Order (HO) corrector magnets for the High Luminosity-LHC (HL-LHC) project, which will equip the interaction regions. Five prototypes, from skew quadrupole to dodecapole, have been designed and tested at LASA. [...]
2021 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 31 (2021) 1-5
|
|
|
6.
|
Design Study of the Nb₃Sn Cos-Theta Dipole Model for FCC-hh
/ Valente, Riccardo U (INFN, Milan) ; Burioli, Sergio (INFN, Genoa ; Genoa U.) ; De Matteis, Ernesto (INFN, Milan) ; Fabbricatore, Pasquale (INFN, Genoa) ; Farinon, Stefania (INFN, Genoa) ; Lackner, Friedrich (CERN) ; Levi, Filippo (INFN, Genoa ; Genoa U.) ; Mariotto, Samuele (INFN, Milan) ; Musenich, Riccardo (INFN, Genoa) ; Pampaloni, Alessandra (INFN, Genoa) et al.
In the context of the Future Circular Collider hadron-hadron (FCC-hh) R&D; program, the Italian Institute of Nuclear Physics (INFN), in collaboration with CERN, is responsible for designing and constructing the Falcon Dipole (Future Accelerator post-LHC Costheta Optimized Nb₃Sn Dipole), which is an important step towards the construction of High Field Nb₃Sn magnets for a post LHC collider. The magnet is a short model with one aperture of 50 mm and the target bore field is 12 T (14 T ’ultimate’ field). [...]
JACoW, 2021 - 4 p.
- Published in : JACoW IPAC 2021 (2021) 2421-2424
Fulltext: PDF;
In : 12th International Particle Accelerator Conference (IPAC 2021), Online, 24 - 28 May 2021, pp.2421-2424
|
|
|
7.
|
Activity on the Sextupole Round Coil Superferric Magnet Prototype at LASA
/ Mariotto, Samuele ; Leone, Augusto ; Paccalini, Antonio ; Pasini, Alessandro ; Pedrini, Danilo ; Quadrio, Mauro ; Sorbi, Massimo ; Statera, Marco ; Todero, Maurizio ; Valente, Riccardo
The LASA Laboratory (INFN, Milan, Italy) is developing an unconventional type of superferric magnets suitable to arbitrary multipole order, which we refer to as round coil superferric magnets. This type of magnet is suitable for strain-sensitive superconductors because it uses round coils with large bending radius to create the magnetic field, while the round yoke with arbitrary multipoles is able to create the desired harmonic component for the magnet. [...]
2019 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 29 (2019) 4004505
|
|
|
8.
|
Preliminary Design of the NB$_3$Sn $cos$ $\theta$ Short Model for the FCC
/ Pampaloni, Alessandra (INFN, Genoa) ; Bellomo, Giovanni (Milan U. ; LASA, Segrate) ; Burioli, Sergio (INFN, Genoa ; U. Genoa) ; De Matteis, Ernesto (LASA, Segrate) ; Fabbricatore, Pasquale (INFN, Genoa) ; Farinon, Stefania (INFN, Genoa) ; Lackner, Friedrich (CERN) ; Levi, Filippo (INFN, Genoa ; U. Genoa) ; Mariotto, Samuele (Milan U. ; LASA, Segrate) ; Musenich, Riccardo (INFN, Genoa) et al.
The next generation particle accelerators will need to increase by an order of magnitude the center-of-mass energy: a viable solution is a 100 TeV circular collider, temporarily called Future Circular Collider (FCC). To achieve this goal, a new generation of double aperture superconducting magnets, capable of generating a high quality, stable 16 T magnetic field in a 50 mm bore is being developed. [...]
2021 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 31 (2021) 4900905
|
|
|
9.
|
Construction and Power Test of the Superferric Skew Quadrupole for HL-LHC
/ Statera, Marco (INFN, Milan) ; Alessandria, Franco (INFN, Milan) ; Bellomo, Giovanni (INFN, Milan ; Milan U.) ; Broggi, Francesco (INFN, Milan) ; Leone, Augusto (INFN, Milan) ; Mariotto, Samuele (INFN, Milan ; Milan U.) ; Paccalini, Antonio (INFN, Milan) ; Pasini, Alessandro (INFN, Milan) ; Pedrini, Danilo (INFN, Milan) ; Prioli, Marco (INFN, Milan) et al.
INFN is developing at LASA laboratory (Milano, Italy) the prototypes of five high order corrector magnets, from skew quadrupole to dodecapole, which will equip the high-luminosity interaction regions of the High Luminosity-LHC (HL-LHC). These magnets are based on a superferric design, which allows a relatively simple, modular and easy to construct magnet. [...]
2020 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 30 (2020) 4003805
|
|
|
10.
|
Construction and cold test of the superferric dodecapole high order corrector for the LHC High Luminosity upgrade
/ Sorbi, Massimo (Milan U. ; LASA, Segrate) ; Alessandria, Franco (LASA, Segrate) ; Bellomo, Giovanni (Milan U. ; LASA, Segrate) ; Broggi, Francesco (LASA, Segrate) ; Campaniello, Marco (SAES Getters, Milan) ; Canetti, Marco (Rial Vacuum, Parma) ; Fumagalli, Alessandro (SAES Getters, Milan) ; Gangini, Fabrizio (Rial Vacuum, Parma) ; Leone, Augusto (LASA, Segrate) ; Mariotto, Samuele (Milan U. ; LASA, Segrate) et al.
The High Luminosity LHC (HL-LHC) is a program to upgrade the performance of the collider in order to achieve, in the ATLAS and CMS collision regions, instantaneous luminosities a factor of five larger than the actual nominal value. To obtain this result, all the magnets in the collision region will have to be substituted, together with other important devices. [...]
2019 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 29 (2019) 4001905
|
|