Large panel system building

Prefabrication was pioneered in the Netherlands following World War I, based on construction methods developed in the United States. The first German use of large panel system-building construction is what is now known as the Splanemann-Siedlung in Berlin's Lichtenberg district, constructed in 1926–1930.^[1] These two- and three-storey apartment houses were assembled of locally cast slabs, inspired by the Dutch Betondorp in Watergraafsmeer, a suburb of Amsterdam.

 

In East Germany, large panel system-building areas have been designated as Neubaugebiet ("New development area"). Virtually all new residential buildings since the 1960s were built in this style, as it was a quick and relatively inexpensive way to curb the country's severe housing shortage, which had been caused by wartime bombing raids and the large influx of German refugees from further east. At the same time, many buildings from earlier eras had substantial drawbacks, such as coal heat, no hot running water, or bathrooms shared by multiple units. As these buildings fell into disrepair, many of their inhabitants moved into newer large panel system-building housing. Today, large panel system-buildings are often no longer desirable, due in part to both their low thermal efficiency, and their rapid deterioration as a result of their vulnerability to damp ingress and their cheap and quick construction methods, while older housing stock has undergone extensive renovation or been replaced with more modern dwelling units.

There were several common large panel system-building designs. The most common series was the P2, followed by the WBS 70, the WHH GT 18, and Q3A. The designs were flexible and could be built as towers or rows of apartments of various heights. The short sides of building blocks often featured large-scale murals or colourful mosaics.

Since the entire building had a standard structure, apartment layouts were also standardized. Furniture producers used this to offer prefabricated sets that matched a variety of typical apartment setups.

 

There have been projects with low rise "Plattenbauten" such as the town of Bernau just north of Berlin. This town had an almost complete historic center of mainly wooden framed buildings within its preserved city walls. Most of these were torn down after 1975 and during the eighties to be replaced by 2–4 storey buildings constructed of prefabricated concrete slabs. To fit in with the medieval church and the almost complete city wall, the houses used rather small design units and decreased in height the farther away they were from the Church and the nearer they came to the city wall. A similar project was the Nikolaiviertel around the historic Nikolai church in Berlin's old centre. In the case of the Nikolaiviertel the buildings were made to look more historic.

Large panel system-building apartments were once considered highly desirable in East Germany, largely due to the lack of any other viable alternative. The main alternatives of the time were overcrowded, deteriorating prewar housing, often with wartime damage still visible, due to policies that preferred new construction over repairing the damaged housing stock. Plattenbau suburbs were planned not only for apartment buildings, but included schools, shopping centers, hospitals, restaurants and recreational facilities. Commercial areas were either on the ground floor of high-rise apartment blocks, or in separate structures. Since few citizens owned cars, the developments were planned to include tramways, subways and bus lines.

Since reunification a combination of decreasing population, renovation of older buildings, and construction of modern alternative housing has led to high vacancy rates, with some estimates placing the number of unoccupied units at around a million. Many large panel system-building apartments were built in giant settlements, often on the edge of cities (such as Marzahn and Hellersdorf in Berlin and Halle-Neustadt), making them inconveniently located.^{[citation needed]}

While some large panel system-building apartments have been being torn down, many are renovated to a modern standard. Especially in bigger cities, these districts are slowly getting more popular again, since they provide affordable apartments and often walkable environments with good public transport systems.

Berlin-based architect David Chipperfield has suggested that the plain appearance of Plattenbau housing does not promote gentrification, and may be a factor that helps preserve social continuity for local residents and neighborhoods.^[2]

 

 

In Finland, particularly in northern towns, such as Rovaniemi, Plattenbauten are commonplace. Rovaniemi was nearly completely destroyed during World War II and subsequently rebuilt from scratch, with new concrete panel buildings replacing old wooden houses and becoming a symbol of modernization.^[3] Whereas in the rest of Europe large panel system-building are associated with public housing, in Rovaniemi they are favoured by the middle classes on their way to purchasing a bungalow.^{[citation needed]}

• Hansaviertel
• HLM (France)
• Million Programme (Sweden)
• Panelház (Hungary)
• Gemeindebau (Austria)
• Panelák and Sídlisko (Czech Republic and Slovakia)
• Panel buildings in Russia
  • Khrushchevka and Brezhnevka (former Soviet Union)
• Ugsarmal bair (Mongolia)
• Housing estate
• Affordable housing
• Public housing
• Subsidized housing
• Structural robustness

Architecture

• Grosvenor Atterbury
• Unité d'Habitation
• Urban planning in communist countries

Safety

• Ronan Point

• Meuser, Philipp; Zadorin, Dimitrij (2016). Towards a Typology of Soviet Mass Housing: Prefabrication in the USSR 1955 – 1991, DOM publishers, Berlin. ISBN 978-3869224466.
• Meuser, Philipp (2019). Prefabricated Housing. Construction and Design Manual, DOM publishers, Berlin. ISBN 978-3-86922-021-5

 

Wikimedia Commons has media related to Plattenbau.

• FIB international Bulletin 43 - structural connections for precast concrete buildings