Steady state (chemistry)

The steady state approximation,^[1] occasionally called the stationary-state approximation or Bodenstein's quasi-steady state approximation, involves setting the rate of change of a reaction intermediate in a reaction mechanism equal to zero so that the kinetic equations can be simplified by setting the rate of formation of the intermediate equal to the rate of its destruction.

In practice it is sufficient that the rates of formation and destruction are approximately equal, which means that the net rate of variation of the concentration of the intermediate is small compared to the formation and destruction, and the concentration of the intermediate varies only slowly, similar to the reactants and products (see the equations and the green traces in the figures below).^{[citation needed]}

Its use facilitates the resolution of the differential equations that arise from rate equations, which lack an analytical solution for most mechanisms beyond the simplest ones. The steady state approximation is applied, for example, in Michaelis-Menten kinetics.

As an example, the steady state approximation will be applied to two consecutive, irreversible, homogeneous first order reactions in a closed system. (For heterogeneous reactions, see reactions on surfaces.) This model corresponds, for example, to a series of nuclear decompositions like ²³⁹U → ²³⁹Np → ²³⁹Pu.

If the rate constants for the following reaction are k₁ and k₂; A → B → C, combining the rate equations with a mass balance for the system yields three coupled differential equations:

For species A: ${\displaystyle {\frac {d[{\ce {A}}]}{dt}}=-k_{1}[{\ce {A}}]}$ 

For species B: ${\displaystyle {\frac {d[{\ce {B}}]}{dt}}=k_{1}[{\ce {A}}]-k_{2}[{\ce {B}}]}$ 

Here the first (positive) term represents the formation of B by the first step A → B, whose rate depends on the initial reactant A. The second (negative) term represents the consumption of B by the second step B → C, whose rate depends on B as the reactant in that step.

For species C: ${\displaystyle {\frac {d[{\ce {C}}]}{dt}}=k_{2}[{\ce {B}}]}$ 

The analytical solutions for these equations (supposing that initial concentrations of every substance except for A are zero) are:^[2]

${\displaystyle [{\ce {A}}]=[{\ce {A}}]_{0}e^{-k_{1}t}}$ 

${\displaystyle \left[{\ce {B}}\right]={\begin{cases}\left[{\ce {A}}\right]_{0}{\frac {k_{1}}{k_{2}-k_{1}}}\left(e^{-k_{1}t}-e^{-k_{2}t}\right);&k_{1}\neq k_{2}\\\\\left[{\ce {A}}\right]_{0}k_{1}te^{-k_{1}t};&k_{1}=k_{2}\\\end{cases}}}$ 

${\displaystyle \left[{\ce {C}}\right]={\begin{cases}\left[{\ce {A}}\right]_{0}\left(1+{\frac {k_{1}e^{-k_{2}t}-k_{2}e^{-k_{1}t}}{k_{2}-k_{1}}}\right);&k_{1}\neq k_{2}\\\\\left[{\ce {A}}\right]_{0}\left(1-e^{-k_{1}t}-k_{1}te^{-k_{1}t}\right);&k_{1}=k_{2}\\\end{cases}}}$ 

If the steady state approximation is applied, then the derivative of the concentration of the intermediate is set to zero. This reduces the second differential equation to an algebraic equation which is much easier to solve.

${\displaystyle {\frac {d[{\ce {B}}]}{dt}}=0=k_{1}[{\ce {A}}]-k_{2}[{\ce {B}}]\Rightarrow \;[{\ce {B}}]={\frac {k_{1}}{k_{2}}}[{\ce {A}}].}$ 

Therefore, ${\displaystyle {\tfrac {d[{\ce {C}}]}{dt}}=k_{1}[{\ce {A}}],}$  so that ${\displaystyle [{\ce {C}}]=[{\ce {A}}]_{0}\left(1-e^{-k_{1}t}\right).}$ 

Since ${\displaystyle [{\ce {B}}]={\tfrac {k_{1}}{k_{2}}}[{\ce {A}}]={\tfrac {k_{1}}{k_{2}}}[{\ce {A}}]_{0}e^{-k_{1}t},}$  the concentration of the reaction intermediate B changes with the same time constant as [A] and is not in a steady state in that sense.

 

 

The analytical and approximated solutions should now be compared in order to decide when it is valid to use the steady state approximation. The analytical solution transforms into the approximate one when ${\displaystyle k_{2}\gg k_{1},}$  because then ${\displaystyle e^{-k_{2}t}\ll e^{-k_{1}t}}$  and ${\displaystyle k_{2}-k_{1}\approx \;k_{2}.}$  Therefore, it is valid to apply the steady state approximation only if the second reaction is much faster than the first (k₂/k₁ > 10 is a common criterion), because that means that the intermediate forms slowly and reacts readily so its concentration stays low.

The graphs show concentrations of A (red), B (green) and C (blue) in two cases, calculated from the analytical solution.

When the first reaction is faster it is not valid to assume that the variation of [B] is very small, because [B] is neither low or close to constant: first A transforms into B rapidly and B accumulates because it disappears slowly. As the concentration of A decreases its rate of transformation decreases, at the same time the rate of reaction of B into C increases as more B is formed, so a maximum is reached when ${\displaystyle t={\begin{cases}{\frac {\ln \left({\frac {k_{1}}{k_{2}}}\right)}{k_{1}-k_{2}}}&\,k_{1}\neq k_{2}\\\\{\frac {1}{k_{1}}}&\,k_{1}=k_{2}\\\end{cases}}}$ 
From then on the concentration of B decreases.

When the second reaction is faster, after a short induction period during which the steady state approximation does not apply, the concentration of B remains low (and more or less constant in an absolute sense) because its rates of formation and disappearance are almost equal and the steady state approximation can be used.

The equilibrium approximation can sometimes be used in chemical kinetics to yield similar results to the steady state approximation. It consists in assuming that the intermediate arrives rapidly at chemical equilibrium with the reactants. For example, Michaelis-Menten kinetics can be derived assuming equilibrium instead of steady state. Normally the requirements for applying the steady state approximation are laxer: the concentration of the intermediate is only needed to be low and more or less constant (as seen, this has to do only with the rates at which it appears and disappears) but it is not required to be at equilibrium.

The reaction H₂ + Br₂ → 2 HBr has the following mechanism:

The rate of each species are:

${\displaystyle {\frac {d[{\ce {H}}Br]}{dt}}=k_{2}[{\ce {B}}r][{\ce {H}}_{2}]+k_{3}[{\ce {H}}][{\ce {B}}r_{2}]-k_{4}[{\ce {H}}][{\ce {H}}Br]}$ 

${\displaystyle {\frac {d[{\ce {H}}]}{dt}}=k_{2}[{\ce {B}}r][{\ce {H}}_{2}]-k_{3}[{\ce {H}}][{\ce {B}}r_{2}]-k_{4}[{\ce {H}}][{\ce {H}}Br]}$ 

${\displaystyle {\frac {d[{\ce {B}}r]}{dt}}=2k_{1}[{\ce {B}}r_{2}]-k_{2}[{\ce {B}}r][{\ce {H}}_{2}]+k_{3}[{\ce {H}}][{\ce {B}}r_{2}]+k_{4}[{\ce {H}}][{\ce {H}}Br]-2k_{5}[{\ce {B}}r]^{2}}$ 

${\displaystyle {\frac {d[{\ce {B}}r_{2}]}{dt}}=-k_{1}[{\ce {B}}r_{2}]-k_{3}[{\ce {H}}][{\ce {B}}r_{2}]+k_{5}[{\ce {B}}r]^{2}}$ 

${\displaystyle {\frac {d[{\ce {H}}_{2}]}{dt}}=-k_{2}[{\ce {B}}r][{\ce {H}}_{2}]+k_{4}[{\ce {H}}][{\ce {H}}Br]}$ 

These equations cannot be solved, because each one has values that change with time. For example, the first equation contains the concentrations of [Br], [H₂] and [Br₂], which depend on time, as can be seen in their respective equations.

To solve the rate equations the steady state approximation can be used. The reactants of this reaction are H₂ and Br₂, the intermediates are H and Br, and the product is HBr.

For solving the equations, the rates of the intermediates are set to 0 in the steady state approximation:

${\displaystyle {\begin{aligned}&{\frac {d[{\ce {H}}]}{dt}}=k_{2}[{\ce {B}}r][{\ce {H}}_{2}]-k_{3}[{\ce {H}}][{\ce {H}}Br]-k_{4}[{\ce {H}}][{\ce {H}}Br]=0\\&\qquad \longrightarrow k_{2}[{\ce {B}}r][{\ce {H}}_{2}]=k_{3}[{\ce {H}}][{\ce {H}}Br_{2}]\end{aligned}}}$ 

${\displaystyle {\frac {d[{\ce {B}}r]}{dt}}=2k_{1}[{\ce {B}}r_{2}]-k_{2}[{\ce {B}}r][{\ce {H}}_{2}]+k_{3}[{\ce {H}}][{\ce {B}}r_{2}]+k_{4}[{\ce {H}}][{\ce {H}}Br]-2k_{5}[{\ce {B}}r]^{2}}$ 

From the reaction rate of H, k₂[Br][H₂] − k₃[H][Br₂] − k₄[H][HBr] = 0 , so the reaction rate of Br can be simplified:

${\displaystyle {\begin{aligned}&2k_{1}[{\ce {B}}r_{2}]-2k_{5}[{\ce {B}}r]^{2}=0\\&\qquad \longrightarrow [{\ce {B}}r]={\frac {k_{1}}{k_{5}}}^{\frac {1}{2}}[{\ce {B}}r]^{\frac {1}{2}}\end{aligned}}}$ 

${\displaystyle {\frac {d[{\ce {H}}Br]}{dt}}=k_{2}[{\ce {B}}r][{\ce {H}}_{2}]+k_{3}[{\ce {H}}][{\ce {B}}r_{2}]-k_{4}[{\ce {H}}][{\ce {H}}Br]}$ 

The reaction rate of HBr can also be simplifed, changing k₂[Br][H₂] − k₄[H][Br] to k₃[H][Br₂], since both values are equal.

${\displaystyle {\begin{aligned}&k_{2}[{\ce {B}}r][{\ce {H}}_{2}]-k_{4}[{\ce {H}}][{\ce {B}}r]=k_{3}[{\ce {H}}][{\ce {B}}r_{2}]\\&\qquad \longrightarrow {\frac {d[{\ce {H}}Br]}{dt}}=2k_{3}[{\ce {H}}][{\ce {B}}r_{2}]\end{aligned}}}$ 

The concentration of H from equation 1 can be isolated:

${\displaystyle [{\ce {H}}]}={\frac {k_{2}[{\ce {B}}r][{\ce {H}}_{2}]}{k_{3}[{\ce {B}}r_{2}]+k_{4}[{\ce {H}}][{\ce {H}}Br]}}={\frac {k_{2}\left({\frac {k_{1}}{k_{5}}}\right)^{\frac {1}{2}}[{\ce {B}}r_{2}]^{\frac {1}{2}}[{\ce {H}}_{2}]}{k_{3}[{\ce {B}}r_{2}]+k_{4}[{\ce {H}}Br]}}$ 

The concentration of this intermediate is small and changes with time like the concentrations of reactants and product. It is inserted into the last differential equation to give

${\displaystyle {\frac {d[{\ce {H}}Br]}{dt}}=2k_{3}[{\ce {H}}][{\ce {B}}r_{2}]=2k_{3}\left\lfloor {\frac {k_{2}\left({\frac {k_{1}}{k_{5}}}\right)^{\frac {1}{2}}[{\ce {B}}r_{2}]^{\frac {1}{2}}[{\ce {H}}_{2}]}{k_{3}[{\ce {B}}r_{2}]+k_{4}[{\ce {H}}Br]}}\right\rfloor [{\ce {B}}r_{2}].}$ 

Simplifying the equation leads to

${\displaystyle {\frac {d[{\ce {H}}Br]}{dt}}={\frac {2k_{3}k_{2}\left({\frac {k_{1}}{k_{5}}}\right)^{\frac {1}{2}}[{\ce {B}}r_{2}]^{\frac {1}{2}}[{\ce {H}}_{2}]}{k_{3}+{\frac {k_{4}[{\ce {H}}Br]}{[{\ce {B}}r_{2}]}}}}.}$ 

The experimentally observed rate is

${\displaystyle v={\frac {k'[{\ce {H}}_{2}][{\ce {B}}r_{2}]^{\tfrac {1}{2}}}{1+k''{\frac {[{\ce {H}}Br]}{[{\ce {B}}r_{2}]}}}}.}$ 

The experimental rate law is the same as rate obtained with the steady state approximation, if ⁠${\displaystyle k'}$ ⁠ is ${\textstyle 2k_{2}{\sqrt {\frac {k_{1}}{k_{5}}}}}$  and ⁠${\displaystyle k''}$ ⁠ is ${\textstyle {\frac {k_{4}}{k_{3}}}}$ .

• Lindemann mechanism
• Reaction progress kinetic analysis
• Steady state (biochemistry)

• https://chem.libretexts.org/Core/Physical_and_Theoretical_Chemistry/Kinetics/Reaction_Mechanisms/Steady-State_Approximation