Audio time stretching and pitch scaling

The simplest way to change the duration or pitch of an audio recording is to change the playback speed. For a digital audio recording, this can be accomplished through sample rate conversion. When using this method, the frequencies in the recording are always scaled at the same ratio as the speed, transposing its perceived pitch up or down in the process. Slowing down the recording to increase duration also lowers the pitch, while speeding it up for a shorter duration respectively raises the pitch, creating the so-called Chipmunk effect. When resampling audio to a notably lower pitch, it may be preferred that the source audio is of a higher sample rate, as slowing down the playback rate will reproduce an audio signal of a lower resolution, and therefore reduce the perceived clarity of the sound. On the contrary, when resampling audio to a notably higher pitch, it may be preferred to incorporate an interpolation filter, as frequencies that surpass the Nyquist frequency (determined by the sampling rate of the audio reproduction software or device) will create usually undesired sound distortions, a phenomenon that is also known as aliasing.

One way of stretching the length of a signal without affecting the pitch is to build a phase vocoder after Flanagan, Golden, and Portnoff.

Basic steps:

1. compute the instantaneous frequency/amplitude relationship of the signal using the STFT, which is the discrete Fourier transform of a short, overlapping and smoothly windowed block of samples;
2. apply some processing to the Fourier transform magnitudes and phases (like resampling the FFT blocks); and
3. perform an inverse STFT by taking the inverse Fourier transform on each chunk and adding the resulting waveform chunks, also called overlap and add (OLA).^[3]

The phase vocoder handles sinusoid components well, but early implementations introduced considerable smearing on transient ("beat") waveforms at all non-integer compression/expansion rates, which renders the results phasey and diffuse. Recent improvements allow better quality results at all compression/expansion ratios but a residual smearing effect still remains.

The phase vocoder technique can also be used to perform pitch shifting, chorusing, timbre manipulation, harmonizing, and other unusual modifications, all of which can be changed as a function of time.

 

Another method for time stretching relies on a spectral model of the signal. In this method, peaks are identified in frames using the STFT of the signal, and sinusoidal "tracks" are created by connecting peaks in adjacent frames. The tracks are then re-synthesized at a new time scale. This method can yield good results on both polyphonic and percussive material, especially when the signal is separated into sub-bands. However, this method is more computationally demanding than other methods.^{[citation needed]}

 

Rabiner and Schafer in 1978 put forth an alternate solution that works in the time domain: attempt to find the period (or equivalently the fundamental frequency) of a given section of the wave using some pitch detection algorithm (commonly the peak of the signal's autocorrelation, or sometimes cepstral processing), and crossfade one period into another.

This is called time-domain harmonic scaling^[5] or the synchronized overlap-add method (SOLA) and performs somewhat faster than the phase vocoder on slower machines but fails when the autocorrelation mis-estimates the period of a signal with complicated harmonics (such as orchestral pieces).

Adobe Audition (formerly Cool Edit Pro) seems to solve this by looking for the period closest to a center period that the user specifies, which should be an integer multiple of the tempo, and between 30 Hz and the lowest bass frequency.

This is much more limited in scope than the phase vocoder based processing, but can be made much less processor intensive, for real-time applications. It provides the most coherent results^{[citation needed]} for single-pitched sounds like voice or musically monophonic instrument recordings.

High-end commercial audio processing packages either combine the two techniques (for example by separating the signal into sinusoid and transient waveforms), or use other techniques based on the wavelet transform, or artificial neural network processing^{[citation needed]}, producing the highest-quality time stretching.

 

In order to preserve an audio signal's pitch when stretching or compressing its duration, many time-scale modification (TSM) procedures follow a frame-based approach.^[6] Given an original discrete-time audio signal, this strategy's first step is to split the signal into short analysis frames of fixed length. The analysis frames are spaced by a fixed number of samples, called the analysis hopsize ${\displaystyle H_{a}\in \mathbb {N} }$ . To achieve the actual time-scale modification, the analysis frames are then temporally relocated to have a synthesis hopsize ${\displaystyle H_{s}\in \mathbb {N} }$ . This frame relocation results in a modification of the signal's duration by a stretching factor of ${\displaystyle \alpha =H_{s}/H_{a}}$ . However, simply superimposing the unmodified analysis frames typically results in undesired artifacts such as phase discontinuities or amplitude fluctuations. To prevent these kinds of artifacts, the analysis frames are adapted to form synthesis frames, prior to the reconstruction of the time-scale modified output signal.

The strategy of how to derive the synthesis frames from the analysis frames is a key difference among different TSM procedures.

For the specific case of speech, time stretching can be performed using PSOLA.

Time-compressed speech is the representation of verbal text in compressed time. While one might expect speeding up to reduce comprehension, Herb Friedman says that "Experiments have shown that the brain works most efficiently if the information rate through the ears—via speech—is the 'average' reading rate, which is about 200–300 wpm (words per minute), yet the average rate of speech is in the neighborhood of 100–150 wpm."^[7]

Listening to time-compressed speech is seen as the equivalent of speed reading.^{[by whom?][8][9]}

 

Pitch shifting (frequency scaling) is provided on Eventide Harmonizer

 

Frequency shifting provided by Bode Frequency Shifter does not keep frequency ratio and harmony.

These techniques can also be used to transpose an audio sample while holding speed or duration constant. This may be accomplished by time stretching and then resampling back to the original length. Alternatively, the frequency of the sinusoids in a sinusoidal model may be altered directly, and the signal reconstructed at the appropriate time scale.

Transposing can be called frequency scaling or pitch shifting, depending on perspective.

For example, one could move the pitch of every note up by a perfect fifth, keeping the tempo the same. One can view this transposition as "pitch shifting", "shifting" each note up 7 keys on a piano keyboard, or adding a fixed amount on the Mel scale, or adding a fixed amount in linear pitch space. One can view the same transposition as "frequency scaling", "scaling" (multiplying) the frequency of every note by 3/2.

Musical transposition preserves the ratios of the harmonic frequencies that determine the sound's timbre, unlike the frequency shift performed by amplitude modulation, which adds a fixed frequency offset to the frequency of every note. (In theory one could perform a literal pitch scaling in which the musical pitch space location is scaled [a higher note would be shifted at a greater interval in linear pitch space than a lower note], but that is highly unusual, and not musical.^{[citation needed]})

Time domain processing works much better here, as smearing is less noticeable, but scaling vocal samples distorts the formants into a sort of Alvin and the Chipmunks-like effect, which may be desirable or undesirable. A process that preserves the formants and character of a voice involves analyzing the signal with a channel vocoder or LPC vocoder plus any of several pitch detection algorithms and then resynthesizing it at a different fundamental frequency.

A detailed description of older analog recording techniques for pitch shifting can be found at Alvin and the Chipmunks § Recording technique.

Pitch-corrected audio timestretch is found in every modern web browser as part of the HTML standard for media playback.^[10] Similar controls are ubiquitous in media applications and frameworks such as GStreamer and Unity.

• Beatmatching
• Dynamic tonality — real-time changes of tuning and timbre
• Pitch correction
• Scrubbing (audio)
• Nightcore

• Time Stretching and Pitch Shifting Overview A comprehensive overview of current time and pitch modification techniques by Stephan Bernsee
• Stephan Bernsee's smbPitchShift C source code C source code for doing frequency domain pitch manipulation
• pitchshift.js from KievII A Javascript pitchshifter based on smbPitchShift code, from the open source KievII library
• The Phase Vocoder: A Tutorial - A good description of the phase vocoder
• New Phase-Vocoder Techniques for Pitch-Shifting, Harmonizing and Other Exotic Effects
• A new Approach to Transient Processing in the Phase Vocoder
• PICOLA and TDHS
• How to build a pitch shifter Theory, equations, figures and performances of a real-time guitar pitch shifter running on a DSP chip
• ZTX Time Stretching Library Free and commercial versions of a popular 3rd party time stretching library for iOS, Linux, Windows and Mac OS X
• Elastique by zplane commercial cross-platform library, mainly used by DJ and DAW manufacturers
• Voice Synth from Qneo - specialized synthesizer for creative voice sculpting
• TSM toolbox Free MATLAB implementations of various Time-Scale Modification procedures
• PaulStretch at the Wayback Machine (archived 2023-02-02), a well-known algorithm for extreme (>10×) time stretching
• Bungee open source and commercial libraries for real time audio stretching
• Rubber Band — open source library for time stretching and pitch shifting
• SoundTouch — open-source library for changing the tempo, pitch and playback rate