Nothing Special   »   [go: up one dir, main page]
Skip to main content
Springer Nature Link
Log in

A novel switch beam design method with extending switching radio-frequency bandwidth

  • Technical Paper
  • Published:
Microsystem Technologies Aims and scope Submit manuscript

Abstract

In this paper, a new switching beam design method is proposed. By using a beam design method to design a beam, an ultra-wideband radio-frequency micro electromechanical system (RF MEMS) switch with a frequency band of 1–110 GHz is designed. With this design method, in addition to using the equivalent capacitance between the switch beam and the signal line, you can also make full use of the fringe field effect between them. Therefore, it can greatly increase the capacitance ratio between the two states of the switch up and down. Finally, it achieves the purpose of extending the working bandwidth of the switch. In the up state, the return loss is less than 20 dB and the bandwidth is greater than 100 GHz. The insertion loss is less than 0.2 dB. The bandwidth is greater than 100 GHz. In the down state, the isolation is less than 10 dB and the bandwidth is greater than 90 GHz.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Log in via an institution

Subscribe and save

Springer+ Basic
$34.99 /Month
  • Get 10 units per month
  • Download Article/Chapter or eBook
  • 1 Unit = 1 Article or 1 Chapter
  • Cancel anytime
Subscribe now

Buy Now

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Institutional subscriptions

Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Fig. 9
Fig. 10

Similar content being viewed by others

References

  • Agarwal S (2017) Modeling and analysis of capacitance in consideration of the deformation in RF MEMS shunt switch. Superlattices Microstruct 101:567–574

    Article  Google Scholar 

  • Bian W (2019) Comparison of MEMS switches and PIN diodes for switched dual tuned RF coils. J Micromech Microeng 29:287–296

    Article  Google Scholar 

  • Chen Z (2017) Effect of surface asperities on the capacitances of capacitive RF MEMS switches. J Micromech Microeng 27:257–268

    Google Scholar 

  • Deng Z (2016) Ka-band radiation pattern reconfigurable antenna based on microstrip MEMS switches. Progr Electromagn Res Lett 59:93–99

    Article  Google Scholar 

  • Heredia J (2019) A 125–143GHz frequency-reconfigurable BiCMOS compact LNA using a single RF-MEMS switch. IEEE Microwave Wirel Compon Lett 29:339–341

    Article  Google Scholar 

  • Jo E (2019) Integration of a carbon nanotube network on a microelectromechanical switch for ultralong contact lifetime. ACS Appl Mater Interfaces 11:18617–18625

    Article  Google Scholar 

  • Kolis P (2017) Quantification of uncertainty in creep failure of RF-MEMS switches. J Microelectromech Syst 26:283–294

    Article  Google Scholar 

  • Krishnan U (2019) A synoptic review of MoS2: synthesis to applications. Superlattices Microstruct 128:274–297

    Article  Google Scholar 

  • Maunder A (2018) Comparison of MEMS switches and PIN diodes for switched dual tuned RF coils. Magn Reson Med 80:1746–1753

    Article  Google Scholar 

  • Park SJ (2010) High–Q RF MEMS 4–6GHz tunable evanescent-mode cavity filter. IEEE Trans Microw Theory Tech 58:381–389

    Article  Google Scholar 

  • Shah U (2017) A 500–750 GHz RF MEMS waveguide switch. IEEE Trans Trans Terahertz Sci Technol 7:326–334

    Article  Google Scholar 

  • Wei H (2017) High on/off capacitance ratio RF MEMS capacitive switches. J Micromech Microeng 27:372–383

    Google Scholar 

  • Xiao H (2018) Design and characterization of millimeter-wave micromachined polymer-based cavity filter with resonant cylinders. Sens Actuators A 284:242–250

    Article  Google Scholar 

  • Xu Y (2017) A novel RF MEMS switch on frequency reconfigurable antenna application. Microsyst Technol 24:3833–3841

    Article  Google Scholar 

  • Xu H (2018) Wide solid angle beam-switching conical conformal array antenna with high gain for 5G applications. IEEE Antennas Wirel Propag Lett 17:2304–2308

    Article  Google Scholar 

  • Zhang Y (2018) A high-linearity SP12T RF MEMS switch using parallel dual-cantilevers for 5G and beyond applications. IEEE Electron Device Lett 39:1608–1611

    Google Scholar 

Download references

Acknowledgements

The author sincerely thanks to the Key Laboratory of Instrumentation Science & Dynamic Measurement (North University of China), Ministry of Education, and the computer and other equipment provided by the School of Instrument and Electronics (North University of China). Funded by the National Natural Science Foundation of China (No. U1637212); National Defense Pre-research Foundation of China (61404130402); Fund for Shanxi “1331 Project” Key Subject Construction; Fund for Key Laboratory (61428050104). Supported by Scientific and Technological Innovation Programs of Higher Education Institutions in Shanxi.

Author information

Authors and Affiliations

  1. Key Laboratory of Instrumentation Science and Dynamic Measurement, Ministry of Education, North University of China, Taiyuan, China

    Ruijie Qin, Binzhen Zhang, Cheng Lei, Yongqing Xu, Jiani Qin, Chao Fan, Baoli Mi, Y. Y. Wang & Junping Duan

Authors
  1. Ruijie Qin
    View author publications

    You can also search for this author in PubMed Google Scholar

  2. Binzhen Zhang
    View author publications

    You can also search for this author in PubMed Google Scholar

  3. Cheng Lei
    View author publications

    You can also search for this author in PubMed Google Scholar

  4. Yongqing Xu
    View author publications

    You can also search for this author in PubMed Google Scholar

  5. Jiani Qin
    View author publications

    You can also search for this author in PubMed Google Scholar

  6. Chao Fan
    View author publications

    You can also search for this author in PubMed Google Scholar

  7. Baoli Mi
    View author publications

    You can also search for this author in PubMed Google Scholar

  8. Y. Y. Wang
    View author publications

    You can also search for this author in PubMed Google Scholar

  9. Junping Duan
    View author publications

    You can also search for this author in PubMed Google Scholar

Corresponding author

Correspondence to Binzhen Zhang.

Additional information

Publisher's Note

Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.

Rights and permissions

Reprints and permissions

About this article

Check for updates. Verify currency and authenticity via CrossMark

Cite this article

Qin, R., Zhang, B., Lei, C. et al. A novel switch beam design method with extending switching radio-frequency bandwidth. Microsyst Technol 27, 315–324 (2021). https://doi.org/10.1007/s00542-020-04956-w

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1007/s00542-020-04956-w

Search

Navigation