Connector Pinouts

A P P E N D I X C

Connector Pinouts

This chapter shows the pin signal assignments (pinouts) for the three-connector cable dongle (FIGURE C-1).

FIGURE C-1 Three-Connector Cable Dongle (UCP-3)

Figure shows the three-connector dongle and USB, RJ-45 and VGA video connectors.

Note - The older four-connector cable dongle (UCP-4) can also be used on the Sun Netra T6340 server module, with some restrictions. The Sun Netra T6340 does not support use of the UCP-4 dongle’s RJ-45 connector.

C.1 RJ-45 Serial Connector

FIGURE C-2 RJ-45 Serial Connector on the Cable Dongle

Front view of RJ45 connector shows Pin 8 on left bottom, pin 1 on right bottom.

TABLE C-1 RJ-45 Connector Pin Assignments
Pin Number	Signal	Pin Number on Universal Connector
7	DSR	21
6	RxD	22
1	RTS	23
3	TxD	24
8	CTS	25
2	DTR	26
7	DCD	27
4, 5	GND	29

C.2 USB Connectors

FIGURE C-3 Dual USB 2.0 Connector Pin Assignments

Figure shows pinouts for dual USB cable.

TABLE C-2 USB 2.0 Connector Pinout
Pin Number	Signal	Pin Number on Universal Connector
1	USB1 VCC Red	14, 15
2	USB1 DN white	12
3	USB1 DP Green	13
4	USB1 GND Black	11
5	USB2 VCC Orange	16, 17
6	USB2 DN Yellow	18
7	USB2 DP Blue	19
8	USB2 GND Brown	20

C.3 HD15 Video Output Connector

FIGURE C-4 and TABLE C-3 show the XVR-50 graphics accelerator HD15 connector and pinout signals.

The console video output port connects to the 15-pin connector on the cable dongle. The HD15 video connector supports DDC2 monitor support and Display Power Management Signaling (DPMS).

FIGURE C-4 XVR-50 Graphics Accelerator HD15 Connector Pin Assignments

Figure shows the HD15 connector with numbered pinouts.

TABLE C-3 XVR-50 Graphics Accelerator HD15 Connector Pinout
Pin Number	Signal	Pin Number on Universal Connector
1	Red analog video	2
2	Green analog video	3
3	Blue analog video	4
4	No Connect	-
5	Ground	shell
6	Ground
7	Ground	shell
8	Ground
9	+5V Supply, black	1
10	Ground
11	No Connect	shell
12	Monitor ID1 (DAT, white)
13	Horizontal Sync, orange
14	Vertical Sync, yellow
15	Monitor ID2, red	11

C.4 Using the Cable Dongle

Caution - The cable dongle is for temporary connections only. The cable dongle has not been evaluated for electromagnetic compatibility (EMC). The cable dongle or server module connectors could be damaged by closing rack doors or other impacts. Remove the cable dongle during normal system operation.