|
1.
|
Development and test of single-bore $Cos \vartheta$ Nb$_3$Sn dipole models with cold iron yoke
/ Andreev, N (Fermilab) ; Ambrosio, G (Fermilab) ; Barzi, E (Fermilab) ; Carcagno, R (Fermilab) ; Chichili, D R (Fermilab) ; DiMarco, J (Fermilab) ; Feher, S (Fermilab) ; Imbasciati, L (Fermilab) ; Kashikhin, V V (Fermilab) ; Lamm, M (Fermilab) et al.
Two short Nb$_3$Sn dipole models based on a single-bore cos-theta coil with a cold iron yoke were fabricated and tested at Fermilab. This paper summarizes the details of magnet design and fabrication procedure, and reports the test results including quench performance and quench heater studies, and the magnetic measurements..
FERMILAB-CONF-01-380.-
2002 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 12 (2002) 332-336
Fulltext: PDF;
In : 17th International Conference on Magnet Technology, CERN, Geneva, Switzerland, 24 - 28 Sep 2001, pp.332-336
|
|
|
2.
|
Development and test of Nb$_3$Sn cos-theta dipoles based on PIT strands
/ Zlobin, A V (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Barzi, E (Fermilab) ; Bossert, R (Fermilab) ; Carcagno, R (Fermilab) ; Chichili, D R (Fermilab) ; Elementi, L (Fermilab) ; Feher, S (Fermilab) ; Kashikhin, V V (Fermilab) et al.
Fermilab is involved in the development of new generation high-field accelerator magnets using state-of-the-art Nb$_3$Sn strands produced using different technologies. Two 1-m long models-mirror configuration and dipole magnet-were fabricated recently at Fermilab based on powder-in-tube (PIT) Nb$_3$Sn strands with small effective filament size. [...]
FERMILAB-CONF-04-274-TD.-
2005 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 15 (2005) 1160-1163
Fulltext: PDF; External link: Fermilab Library Server (fulltext available)
In : Applied Superconductivity Conference: Harnessing the Magic, Jacksonville, FL, USA, 3 - 8 Oct 2004, pp.1160-1163
|
|
|
3.
|
Test results of shell-type Nb$_3$Sn dipole coils
/ Feher, S (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Barzi, E (Fermilab) ; Carcagno, R (Fermilab) ; Chichili, D R (Fermilab) ; Kashikhin, V (Fermilab) ; Kashikhin, V V (Fermilab) ; Lamm, M J (Fermilab) ; Orris, D (Fermilab) et al.
Several different shell type coils were made by using the 'wind-and-react' technique, installed in a mirror magnet configuration and tested at Fermilab. The results revealed that the previously suspect splice technique is adequate and is not responsible for the quench performance limitation. [...]
FERMILAB-FN-0864-TD.-
2004 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 14 (2004) 349-352
In : 18th International Conference on Magnet Technology, Morioka, Japan, 20 - 24 Oct 2003, pp.349-352
|
|
|
4.
|
Alternative Mechanical Structure for LARP Nb$_3$Sn Quadrupoles
/ Anerella, M (Brookhaven) ; Cozzolino, J (Brookhaven) ; Ambrosio, G (Fermilab) ; Caspi, S (LBL, Berkeley) ; Felice, H (LBL, Berkeley) ; Kovach, P (Brookhaven) ; Lamm, M (Fermilab) ; Sabbi, G (LBL, Berkeley) ; Schmalzle, J (Brookhaven) ; Wanderer, P (Brookhaven)
An alternative structure for the 120 mm Nb$_3$Sn quadrupole magnet presently under development for use in the upgrade for LHC at CERN is presented. The goals of this structure are to build on the existing technology developed in LARP with the LQ and HQ series magnets and to further optimize the features required for operation in the accelerator. [...]
2011 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 21 (2011) 1773-1776
In : Applied Superconductivity Conference 2010, Washington, DC, USA, 1 - 6 Aug 2010, pp.1773-1776
|
|
|
5.
|
Field Quality Study of the LARP Nb$_3$Sn 3.7 m-Long Quadrupole Models of LQ series
/ Velev, G V (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Anerella, M (Brookhaven Natl. Lab.) ; Bossert, R (Fermilab) ; Caspi, S (LBNL, Berkeley) ; Chlachidze, G (Fermilab) ; DiMarco, J (Fermilab) ; Escallier, J (Brookhaven Natl. Lab.) ; Felice, H (LBNL, Berkeley) et al.
After the successful test of the first long Nb$_3$Sn quadrupole magnet (LQS01), the US LHC Accelerator Research Program (LARP) has assembled and tested a new 3.7 m-long Nb$_3$Sn quadrupole (LQS02). This magnet has four new coils made of the same conductor as LQS01 coils, and it is using the same support structure. [...]
2012 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 22 (2012) 9002804
In : 22nd International Conference on Magnet Technology, Marseille, France, 12 - 16 Sep 2011, pp.9002804
|
|
|
6.
|
Mechanical Design, Assembly and Testing of a Support Structure for LARP Nb$_3$Sn Quadrupole Magnets for LHC
/ Schmalzle, J (Brookhaven) ; Ambrosio, G (Fermilab) ; Anerella, M (Brookhaven) ; Caspi, S (LBL, Berkeley) ; Cozzolino, J (Brookhaven) ; Felice, H (LBL, Berkeley) ; Ferracin, P (LBL, Berkeley) ; Kovach, P (Brookhaven) ; Lamm, M (Fermilab) ; Sabbi, G (LBL, Berkeley) et al.
A support structure for the 120 mm Nb$_3$Sn quadrupole magnet is presently under development for use in the upgrade for LHC at CERN. The design aims to build on existing technology developed in LARP with the LQ and HQ mag- nets and to further optimize the features required for operation in the accelerator. [...]
2012 - 3 p.
- Published in : IEEE Trans. Appl. Supercond. 22 (2012) 4003503
In : 22nd International Conference on Magnet Technology, Marseille, France, 12 - 16 Sep 2011, pp.4003503
|
|
|
7.
|
Progress in the long $Nb_3Sn$ quadrupole R&D by LARP
/ Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Anerella, M (Brookhaven) ; Barzi, E (Fermilab) ; Bocian, D (Fermilab) ; Bossert, r (Fermilab) ; Buehler, M (Fermilab) ; Caspi, S (LBL, Berkeley) ; Chlachidze, G (Fermilab) ; Dietderich, D (LBL, Berkeley) et al.
After the successful test of the first long quadrupole (LQS01) the US LHC Accelerator Research Program (LARP, a collaboration of BNL, FNAL, LBNL and SLAC) is assessing training memory, reproducibility, and other accelerator quality features of long quadrupole magnets. LQS01b (a reassembly of LQS01 with more uniform and higher pre-stress) was subjected to a full thermal cycle and reached the previous plateau of 222 T/m at 4.5 K in two quenches. [...]
FERMILAB-PUB-11-432-TD.-
2012 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 22 (2012) 4003804
Fulltext: PDF; External link: FERMILABPUB
In : 22nd International Conference on Magnet Technology, Marseille, France, 12 - 16 Sep 2011, pp.4003804
|
|
|
8.
|
Test Results of the First 3.7 m long Nb$_3$Sn Quadrupole by LARP and Future Plans
/ LARP Collaboration
In December 2009 during its first cold test, LQS01, the first Long Nb$_3$Sn Quadrupole made by LARP (LHC Accelerator Research Program, a collaboration of BNL, FNAL, LBNL and SLAC), reached its target field gradient of 200 T/m. This target was set in 2005 by the US Department of Energy, CERN and LARP, as a significant milestone toward the development of Nb$_3$Sn quadrupoles for possible use in LHC luminosity upgrades. [...]
FERMILAB-PUB-10-312-TD.-
2010 - 5 p.
- Published in : IEEE Trans. Appl. Supercond. 21 (2010) 1858-1862
Fulltext: PDF; External link: FERMILABPUB
In : Applied Superconductivity Conference 2010, Washington, DC, USA, 1 - 6 Aug 2010, pp.1858-1862
|
|
|
9.
|
Field Quality of the First LARP Nb$_3$Sn 3.7m-Long Quadrupole Model of LQ Series
/ Velev, G V (Fermilab) ; Ambrosio, G (Fermilab) ; Andreev, N (Fermilab) ; Anerella, M (Brookhaven) ; Bossert, R (Fermilab) ; Caspi, S (LBL, Berkeley) ; Chlachidze, G (Fermilab) ; DiMarco, J (Fermilab) ; Escallier, J (Brookhaven) ; Felice, H (LBL, Berkeley) et al.
The US-LHC accelerator research program (LARP) built and tested the first 3.7-m long Nb$_3$Sn quadrupole model of LQ series with a 90 mm bore diameter and a target field gradient of 200 T/m. The LQ series, developed in collaboration among FNAL, LBNL and BNL, is a scale up of the previously tested 1-m long technology quadrupoles of TQ series based on similar coils and two different mechanical structures (shell-based TQS and collar-based TQC), with a primary goal of demonstrating the Nb$_3$Sn accelerator magnet technology for the luminosity upgrade of LHC interaction regions. [...]
FERMILAB-CONF-10-270-TD.-
2011 - 4 p.
- Published in : IEEE Trans. Appl. Supercond. 21 (2011) 1688-1691
Fulltext: PDF; External link: FERMILABCONF
In : Applied Superconductivity Conference 2010, Washington, DC, USA, 1 - 6 Aug 2010, pp.1688-1691
|
|
|
10.
|
|